RimfireCentral.com Forums - View Single Post - Model 60 Charging Handle Problem
View Single Post
Old 03-12-2019, 09:05 PM
NRA Member - Click Here To Join!

Join Date: 
Oct 2009
TPC Rating: 
0% (0)
If you can remove the action and then pull the bolt back and tilt the front of the bolt up slightly you can remove the charging handle. Make sure the small tab on the opposite end of the charging handle is still there. If you completely remove the bolt, being careful to not kink the spring, you can clean the receiver including the small round hole in the side of the receiver. The small hole is where the charging handle tab inserts to hold the bolt back. The hole may be gunked up.
Reply With Quote