RimfireCentral.com Forums - View Single Post - Still another 10/22 barrel remover
View Single Post
  #6  
Old 02-24-2016, 06:36 PM
MiamiDave
NRA Member - Click Here To Join! Appleseed Rifleman

Join Date: 
Oct 2014
Location: 
Fort Lauderdale
Posts: 
698
TPC Rating: 
100% (8)
Good thought assuming you have a rear cleaning hole drilled. If not and you don't want to drill one, a similar piece could be made by using a turnbuckle in the middle and cutting the main rod into two pieces. The turnbuckle is reverse threaded so both rods will expand when turned. It would be a snug fit for the wrench, but I think it would work. Add a nut or something at the rear to spread the load so as not to crack the receiver. Dave