RimfireCentral.com Forums - View Single Post - Weaver G4 Disassembly
View Single Post
  #10  
Old 11-05-2014, 10:38 PM
KimFella

Join Date: 
Apr 2012
Posts: 
7
TPC Rating: 
0% (0)
Quote:
Originally Posted by ShootsAtSky View Post
The reticle should have been on or very near the ring that the adjuster screws contact. In this design, only the reticle itself moves, the masks (flat brass washers with smallish holes) didn't move with it, so the reticle moved around in the field of view. Not like newer designs where the mask moves with the reticle carrier, so it always appears centered, at the expense of up to 30% of the possible field of view.

Bob
"the ring that the adjuster screws contact" being the thing that looks like a ladle with a hole in it? Everything else in there looks like a lens or a "mask". If it is the "ladle" then that solves the alignment problem. I was dreading the thought of putting the crosshairs on a lens or mask and then trying to reassemble the scope so the crosshairs are aligned with the turrets.

I've already collected a crosshair kit from my hair brushes.
Reply With Quote