RimfireCentral.com Forums - View Single Post - Turning my TOZ into Super TOZ-78-01
View Single Post
  #8  
Old 05-28-2010, 09:15 AM
midwest swiss's Avatar
midwest swiss
NRA Member - Click Here To Join!

Join Date: 
Sep 2005
Location: 
minnesota
Posts: 
5,232
TPC Rating: 
0% (0)
I guess it kind of depends how bad your rifles bolt or receiver is....too use sand paper 1st.
Here is a picture of one of my CZ's bolt part that was really bad & the wet dry sand paper was the only way to go.
Or send the rifle back to CZ.

Thats one of the reasons that Cooper & Anschutz rifles cost so much. (more quality control at the factory) & that cost $$$
JB is like 1200 grit & is lab-grade volcanic ash and is non-embedding....from what I have read.
If a person uses valve lapping compound you run the risk of embedding the compound into the steel of your bolt...not good.

Swiss

Last edited by midwest swiss; 12-30-2011 at 07:55 PM.
Reply With Quote