RimfireCentral.com Forums - View Single Post - CM-2 side Scope mount Homemade
View Single Post
  #10  
Old 04-27-2009, 04:20 PM
mrmosin

Join Date: 
Oct 2002
Posts: 
266
TPC Rating: 
100% (3)
Find a Harbor Freight tool co and buy a drill press, vise, and buy drill and tap from midway along with fasterners.One of the guys at the club used a hand drill to D&T his. I had thought that D&T the side rail would not be as bad as the receiver. Could be covered up pretty easy if you re-sold the rifle.
Anyway, a couple of bolts could hold part A to the rail, and bedding compound would fill in any voids. Or buy some of the 2"X2"X.250 angle from the above company and find a machinest cut the dovetail. Then you have only one piece of metal
Reply With Quote