RimfireCentral.com Forums - View Single Post - CM-2 side Scope mount Homemade
View Single Post
  #8  
Old 04-27-2009, 01:41 PM
mrmosin

Join Date: 
Oct 2002
Posts: 
266
TPC Rating: 
100% (3)
I was thinking more along the lines that part A would be more of a permant mount to the dovetail. Maybe 3 screws, part A threaded drawing part A tight against the rail. Could be epoxied to the rail, also. Then part A would be tapped for screws from part B. The holes in part B [not tapped] could be slightly oversize for minor movement and placement of part B. You could even tap the top of part B, front and rear, for some leveling screws.
More as I think thru this
Reply With Quote