RimfireCentral.com Forums - View Single Post - 597 peened breach face and webbing on new jarvis barrel
View Single Post
  #26  
Old 09-04-2019, 10:48 AM
GladesGuy's Avatar
GladesGuy
NRA Member - Click Here To Join!

Join Date: 
Mar 2013
Location: 
So. Fla.
Posts: 
2,974
TPC Rating: 
0% (0)
The more I look at that breech face, the more it seems that the problem might be that the barrel is sitting a tiny bit too far into the receiver and the bolt is rebounding against the breech face more than it should. I wonder if you could try shimming the barrel so that it sits slightly more forward in the receiver. Perhaps a shim made out of an aluminum coke can. I mention this because if I remember correctly, early Jarvis barrels had a problem alighning with the receiver and some folks had to file the reciever a tad to get barrels to fit. This may be the opposite problem.
Reply With Quote