RimfireCentral.com Forums - View Single Post - PPQ 22 Trigger Job?
View Single Post
  #22  
Old 10-30-2017, 05:41 PM
pistolboo's Avatar
pistolboo

Join Date: 
Sep 2016
Posts: 
186
TPC Rating: 
0% (0)
Your last post 1917, that's pretty much what I've decided to do. Now that the sear/hammer interface has been greased the trigger is pretty **** good, no noticeable creep. The engagement distance would be about one mm so that's not going to be reduced, thanks for your thoughts, they have helped a lot.

edit - if this procedure was applied to a car engine it would be called 'blueprinting'.

Last edited by pistolboo; 10-30-2017 at 05:47 PM.
Reply With Quote