RimfireCentral.com Forums - View Single Post - Pinned firing pin
View Single Post
  #16  
Old 03-19-2019, 08:23 PM
bubba68's Avatar
bubba68
NRA Member - Click Here To Join!

Join Date: 
Aug 2013
Location: 
Columbus, Ohio
Posts: 
183
TPC Rating: 
0% (0)


Log in to see fewer ads
Quote:
Originally Posted by Chaser View Post
Yupp.. I tell ya almost nothing about these 10/tweekie2's is identical.. almost/sorta/kinda is a pain.. that's why I mentioned spreading the pin.. and the JB Weld is a nice touch Another method I remember using to spread the pin is clamping it in ViceGrips or the Bench Vise to give it a tad OVAL shape.. bingo.
When I was using the JB Weld I was thinking why not use the JB and make a bridge across the firing pin channel then when it is dry go in with a needle file and file the JB enough to let the firing pin through. If you were careful you could make the opening just a few thousands bigger than the pin. There is virtually no upward pressure from the firing pin so I would think the JB would last forever.

Thoughts ?
Reply With Quote