RimfireCentral.com Forums - View Single Post - FTF
Thread: FTF
View Single Post
  #3  
Old 04-25-2021, 09:25 PM
Toomany22s's Avatar
Toomany22s
NRA Member - Click Here To Join!

Join Date: 
Sep 2017
Location: 
Hoosierville
Posts: 
7,540
TPC Rating: 
100% (2)
First, stop forcing anything! All these parts were designed to slip in and function freeand smooth.

Take it apart, .

The handle goes in first , the rod end should be up against the little nub in the back of the receiver.

Pull handle down about an inch . Hold in place .

Slide bolt in and over handle .

Push down on bolt

While moving handle so it pops into slot.

The bolt should run freely.

Look at top of trigger group. Everthing should be in place. The extractor in its slot,
The pins all in and the bolt release and magazine release and plunger all in place and pinned .

Insert trigger group all pinholes should perfectly line up
Spray everything, including the magazine with Hornady oneshot dri lube.
Reply With Quote