RimfireCentral.com Forums - Search Results

Go Back   RimfireCentral.com Forums >

Join Team RFC to remove these ads.
Showing results 1 to 25 of 500
Search took 0.03 seconds.
Search: Posts Made By: VertFish
Forum: Winchester 52 11-19-2020, 10:44 PM
Replies: 23
Views: 888
Posted By VertFish
An original C sporter in average condition is...

An original C sporter in average condition is worth $3,500.00 all day long. I would not even consider the other 2.
Forum: Rifle 11-18-2020, 02:25 PM
Replies: 0
Views: 106
Posted By VertFish
Help with Rem 700 American Hunter

I am retiring my 700 BDL in 6MM Rem. because the twist rate will not stabilize a bullet over 80 grains. I bought the Rem. 700 American Hunter in 6.5 CM. I have 120, 130 and 140 grain bullets I am...
Forum: Kimber 11-10-2020, 04:07 PM
Replies: 4
Views: 343
Posted By VertFish
The standard Super Continentals had AAA Claro,...

The standard Super Continentals had AAA Claro, butter knife bolt handles and 22LPI checkering. The early guns had a panel checkering and the later ones had wrapped checkering.

As far as other...
Forum: Kimber 11-09-2020, 08:44 AM
Replies: 6
Views: 490
Posted By VertFish
Or possibly a tree farmer with a Thesaurus and...

Or possibly a tree farmer with a Thesaurus and lots of free time on my hands while the deciduous trees are shedding.
Forum: Kimber 11-08-2020, 08:29 PM
Replies: 6
Views: 490
Posted By VertFish
The B was the quintessence of the 82 iterations.

The B was the quintessence of the 82 iterations.
Forum: Kimber 11-08-2020, 08:25 PM
Replies: 3
Views: 339
Posted By VertFish
I have never seen one with the magazine floor...

I have never seen one with the magazine floor plate stamped “Kimber”. I also have never seen a plastic follower in a 4 or 5 round Kimber Mag.
Forum: Model 37/40X 11-02-2020, 11:19 PM
Replies: 7
Views: 534
Posted By VertFish
When it comes to ammo preference, there are many...

When it comes to ammo preference, there are many factors that make it impossible to definitively answer your questions. I have seen my best ammo in 85 degree weather shoot badly in 60 degrees and...
Forum: Model 37/40X 11-02-2020, 07:11 AM
Replies: 7
Views: 534
Posted By VertFish
Welcome to RFC! I can't open your group shot...

Welcome to RFC! I can't open your group shot pic. My guess is you need to make them public. Don't waste below average ammo on an excellent target rifle. Testing ammo means you need to buy a couple...
Forum: Kimber 11-01-2020, 11:20 AM
Replies: 22
Views: 1,774
Posted By VertFish
I think one of my competitors for the job may...

I think one of my competitors for the job may have tipped them off that I occasionally practice law. They kinda shy away from having lawyers anywhere near guns.
Forum: Kimber 10-28-2020, 10:32 PM
Replies: 22
Views: 1,774
Posted By VertFish
Finally, a response: Dear Mr. VertFish: ...

Finally, a response:

Dear Mr. VertFish:

Thank you for your interest in the many opportunities working for Kimber Manufacturing, Inc. While your resume’ is very impressive on a number of...
Forum: Kimber 10-27-2020, 10:42 PM
Replies: 22
Views: 1,774
Posted By VertFish
My application for the head of rimfire rifle...

My application for the head of rimfire rifle quality control, development and test target shooter has gone unanswered for two weeks! It may be fake news.
Forum: Kimber 10-27-2020, 08:11 AM
Replies: 17
Views: 608
Posted By VertFish
HAPPY BIRTHDAY SAGE!!!

The best benefit of being a member of RFC has been the friendship that I have developed with John D of southern Oregon. Today is his birthday and I want to wish him the happiest of all birthdays. I...
Forum: Winchester 52 10-22-2020, 05:49 AM
Replies: 12
Views: 797
Posted By VertFish
I might just buy one myself and customize it for...

I might just buy one myself and customize it for my field gun. Thanks 3Dub, that would get me to my 33rd unfinished gun project!!! Grrrrr.
Forum: Kimber 10-22-2020, 05:36 AM
Replies: 29
Views: 2,037
Posted By VertFish
That is a tough question and opinions will vary...

That is a tough question and opinions will vary greatly on the matter. It scores huge bonus points for the nearly exhibition grade Claro, but definite deducts for a non-original factory finish. If I...
Forum: Kimber 10-14-2020, 08:30 PM
Replies: 8
Views: 922
Posted By VertFish
While one would think this is good logic, it is...

While one would think this is good logic, it is actually not always the case. The radius of the receiver and the cut of the dovetail make a proper fit of many rings impossible. This article I wrote...
Forum: Kimber 10-14-2020, 02:17 PM
Replies: 16
Views: 865
Posted By VertFish
I told you it was nice Doug! By the way, its a...

I told you it was nice Doug! By the way, its a Custom Cascade; not a Cascade Custom!!!!!!!
Forum: Rifle 10-14-2020, 08:17 AM
Replies: 3
Views: 424
Posted By VertFish
Another choice is a Warne product, but I do not...

Another choice is a Warne product, but I do not think I have any of them on any of my 82 A or B Kimbers. I do have them on 82 C Kimbers and they fit fine. I believe the C's have the exact same A and...
Forum: Kimber 10-13-2020, 11:55 PM
Replies: 29
Views: 2,037
Posted By VertFish
Well, there you go.......another member of the...

Well, there you go.......another member of the Sagerat stray dog pound!
Bar 5 Ranch’s slogan: “Stray Dogs Are Us”.
Forum: Rifle 10-13-2020, 07:51 AM
Replies: 3
Views: 424
Posted By VertFish
Your gun appears to be a late 82-A Classic. The...

Your gun appears to be a late 82-A Classic. The LH guns are relatively rare, but there is nothing wrong with shooting it some if you don't have the original box and papers. Talley vertically-split...
Forum: Kimber 10-12-2020, 01:19 PM
Replies: 29
Views: 2,037
Posted By VertFish
Well it certainly sounds like the gun has all of...

Well it certainly sounds like the gun has all of the background of a "Certified No Rules Kimber" I'm glad the shepherd of stray dog Kimbers has inspected it. I don't recall seeing Jane last time I...
Forum: Kimber 10-12-2020, 07:27 AM
Replies: 29
Views: 2,037
Posted By VertFish
While I am on a roll pontificating, the other...

While I am on a roll pontificating, the other tell that the finish is not factory was it appears that the checkering has not been totally sealed.

Your photo backdrop does look like a nice one....
Forum: Kimber 10-12-2020, 07:17 AM
Replies: 29
Views: 2,037
Posted By VertFish
[QUOTE=S&WK-22;12053823] If it was my gun, I...

[QUOTE=S&WK-22;12053823]

If it was my gun, I would not have Dennis refinish it. Most of the original KoO finish materials are no longer manufactured and the ones that are still available would...
Forum: Kimber 10-11-2020, 11:05 PM
Replies: 29
Views: 2,037
Posted By VertFish
From the pictures posted, it does not appear to...

From the pictures posted, it does not appear to be a factory finish.
Forum: Winchester 52 10-08-2020, 06:17 AM
Replies: 9
Views: 897
Posted By VertFish
Several months ago I sold a lesser condition B...

Several months ago I sold a lesser condition B Standard Weight with sights that had been refinished and the crown re-profiled for a couple hundred bucks more in one of my local shops on consignment....
Forum: Kimber 10-05-2020, 11:23 AM
Replies: 17
Views: 1,099
Posted By VertFish
They do indeed. KImber went from 4 to 5 rounders...

They do indeed. KImber went from 4 to 5 rounders early on; I'm guessing when they started making their own stocks in house in late 1980/early1981.
Showing results 1 to 25 of 500

 


All times are GMT -5. The time now is 09:28 PM.

Privacy Policy

DMCA Notice

Powered by vBulletin
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Optimisation provided by DragonByte SEO (Lite) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright ©2000-2018 RimfireCentral.com
x