RimfireCentral.com Forums - Search Results

Go Back   RimfireCentral.com Forums >

Notices

Join Team RFC to remove these ads.
Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: 1917-1911M
Forum: Walther 09-19-2021, 05:55 PM
Replies: 16
Views: 2,346
Posted By 1917-1911M
Wanna talk about it? 1917

Wanna talk about it? 1917
Forum: Walther 09-14-2021, 10:51 AM
Replies: 4
Views: 270
Posted By 1917-1911M
Quote from the original thread. During the...

Quote from the original thread. During the discourse you called your pistol a P22 Q model. I take it, it was actually a QD model which incorporated an internal decocking lever. The pistol should...
Forum: Walther 08-31-2021, 10:23 AM
Replies: 8
Views: 448
Posted By 1917-1911M
The trigger bar spring must lift the rear of the...

The trigger bar spring must lift the rear of the trigger bar and keep it up until the cartridge is fired and the blowback gasses move the slide rearward where the ramps under the slide knock the...
Forum: Walther 08-28-2021, 09:46 PM
Replies: 8
Views: 448
Posted By 1917-1911M
I don't remember what I wrote back in 2012. BTW,...

I don't remember what I wrote back in 2012. BTW, I think Walther has a 30 day or 90 day buyback if you don't like a pistol (any of them) that you purchase. Several things could be causing the issue....
Forum: Walther 08-27-2021, 08:14 PM
Replies: 23
Views: 697
Posted By 1917-1911M
You are welcome. Yeah, I've enjoyed shooting...

You are welcome. Yeah, I've enjoyed shooting P22s for years now. I especially enjoy shooting my old 5" with the red dot on it. Now I can actually hit stuff. If you have a suppressor on it you had...
Forum: Walther 08-25-2021, 11:42 PM
Replies: 23
Views: 697
Posted By 1917-1911M
NevRimfire, they don't expect you to work on the...

NevRimfire, they don't expect you to work on the pistol other than clean, lube and use proper ammo. Just shoot it. If it breaks or wear out they will repair or replace. Lifetime warranty. On the...
Forum: Walther 08-24-2021, 08:21 PM
Replies: 23
Views: 697
Posted By 1917-1911M
And if you lay the top, front edge of your...

And if you lay the top, front edge of your trigger bar ears back a bit....this is what the impact area under your slide will look like 50-60,000 rounds later. Barely a mark. Come on Walther....this...
Forum: Walther 08-24-2021, 08:12 PM
Replies: 23
Views: 697
Posted By 1917-1911M
Below is a photo of someone's slide back in about...

Below is a photo of someone's slide back in about 2005. I dded the arrows to explain what was causing the wear. A is where the slide initially impacts the ears to knock the trigger bar down. B is...
Forum: Walther 08-22-2021, 10:07 PM
Replies: 23
Views: 697
Posted By 1917-1911M
There should be a hardened pin at the cut for the...

There should be a hardened pin at the cut for the slide hold open arm. That should prevent wear and rounding off of the edge of the cut. Periodically check the top, rear edge of the slide stop arm. ...
Forum: Walther 08-22-2021, 09:48 PM
Replies: 5
Views: 309
Posted By 1917-1911M
The case on a Stinger is longer than standard...

The case on a Stinger is longer than standard too. That doesn't help. 1917
Forum: Walther 08-20-2021, 10:51 PM
Replies: 5
Views: 309
Posted By 1917-1911M
Good report Frank....yepper, a whole host of...

Good report Frank....yepper, a whole host of problems with short barrel semi auto pistols can be corrected with the proper ammo. The Stingers should work.....but I never shoot them anymore so it...
Forum: RFC Community Forum 08-17-2021, 01:58 PM
Replies: 173
Views: 4,994
Posted By 1917-1911M
Been having this debate with myself for the past...

Been having this debate with myself for the past fifty years. I've tried station wagons, trailers, small truck....I've just come to face it....I need a truck so I have one. Next trip to the farm it...
Forum: Walther 08-01-2021, 12:41 AM
Replies: 6
Views: 597
Posted By 1917-1911M
Appx. 15 years ago the chief engineer in Arnsberg...

Appx. 15 years ago the chief engineer in Arnsberg told me the P22 was tested to 20,000 rounds with CCI Mini Mags. 1917
Forum: Walther 07-03-2021, 09:47 AM
Replies: 114
Views: 22,271
Posted By 1917-1911M
https://i.imgur.com/N56asfy.jpg I didn't...

https://i.imgur.com/N56asfy.jpg

I didn't read the whole thread. This has been some years ago. Germany said they tried it and couldn't make it work. Basically this is some foolishness of mine...
Forum: Walther 06-14-2021, 08:36 AM
Replies: 16
Views: 1,262
Posted By 1917-1911M
bugeye, my comments did not mention wear to the...

bugeye, my comments did not mention wear to the top of the hammer even once. The long time issue has been that the hammer necessarily presses against the bottom of the safety drum and breech rail. ...
Forum: Walther 06-11-2021, 12:08 PM
Replies: 16
Views: 1,262
Posted By 1917-1911M
About everything P22 has been discussed on this...

About everything P22 has been discussed on this forum. You will never get rid of the bottom of the breech block engaging and dragging on the hammer. The hammer rebounds appx. 0.020" after the safety...
Forum: RFC Community Forum 06-08-2021, 03:42 PM
Replies: 36
Views: 1,846
Posted By 1917-1911M
I was out there somewhere a few years back. I...

I was out there somewhere a few years back. I really loved to fish but didn't have any gear with me. Hiking along stream sides not far from camp I'd see guys with all manner of fancy...
Forum: Walther 06-04-2021, 04:07 PM
Replies: 16
Views: 1,262
Posted By 1917-1911M
Yeah the QD with the decocking lever in the...

Yeah the QD with the decocking lever in the breech block didn't last long. I have one and have pictures of the internals.....I can't say that I liked it. It doesn't allow you to cock the hammer with...
Forum: RFC Community Forum 05-29-2021, 02:55 PM
Replies: 10
Views: 458
Posted By 1917-1911M
OK, a group of alligators is called a...

OK, a group of alligators is called a congregation. There, did my part. 1917
Forum: RFC Community Forum 05-22-2021, 07:13 PM
Replies: 70
Views: 1,982
Posted By 1917-1911M
Me either Al but it will be interesting to see...

Me either Al but it will be interesting to see where this goes. They are putting big bucks into the electric Mustang and a utility van as well. One thing seems apparent, with the motors sitting very...
Forum: RFC Community Forum 05-22-2021, 07:07 PM
Replies: 70
Views: 1,982
Posted By 1917-1911M
Yeah, that would aggravate me too. The...

Yeah, that would aggravate me too. The electrical company will not hook up the meter until they are happy with everything. I don't see why an upgrade to the transformer for a residential house...
Forum: RFC Community Forum 05-22-2021, 06:55 PM
Replies: 70
Views: 1,982
Posted By 1917-1911M
A current check of charging stations adjacent to...

A current check of charging stations adjacent to I-20 and I-55 south out of Jackson, MS shows 12 charging stations in the 290 miles I need to travel to the farm. I assume there will be even more...
Forum: RFC Community Forum 05-22-2021, 11:13 AM
Replies: 70
Views: 1,982
Posted By 1917-1911M
My son has a hybrid Toyota SUV and likes it fine...

My son has a hybrid Toyota SUV and likes it fine but it still has an engine and transmission and driveline all of which is expensive, heavy and requires all the maintenance of a gas/diesel...
Forum: RFC Community Forum 05-22-2021, 10:48 AM
Replies: 70
Views: 1,982
Posted By 1917-1911M
How do you figure that? Does your home, area...

How do you figure that? Does your home, area have limited electrical supply? I'm not saying in your case you aren't correct but in the case of my farm house it is a 1929 house way out in the...
Forum: RFC Community Forum 05-21-2021, 03:25 PM
Replies: 70
Views: 1,982
Posted By 1917-1911M
From a recent Car and Driver story. So my...

From a recent Car and Driver story.

So my generator might work. That should probably be extender engine... 1917
Showing results 1 to 25 of 500

 


All times are GMT -5. The time now is 08:16 PM.

Privacy Policy

DMCA Notice

Powered by vBulletin
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Search Engine Optimisation provided by DragonByte SEO (Lite) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
Copyright 2000-2018 RimfireCentral.com
x