RimfireCentral.com Forums - Search Results

Go Back   RimfireCentral.com Forums >

Notices

Join Team RFC to remove these ads.
Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: Flash_80
Forum: Scopes, Sights, Rings & Mounts, and Other Optics 01-20-2020, 12:34 AM
Replies: 2
Views: 180
Posted By Flash_80
Too bright? Do you use it in the dark primarily...

Too bright? Do you use it in the dark primarily or something, because the brightness adjustment to me in the RTS2 doesn't seem to be any issue in daylight shooting. Doubt the STS2 is really any...
Forum: Rimfire Steel Challenge 01-16-2020, 01:16 AM
Replies: 10
Views: 377
Posted By Flash_80
In some arenas, this has been hotly debated. I...

In some arenas, this has been hotly debated. I walk off what I think is around 15yds and dial it in. From that distance locked down on bags, if you back up 10yds or move forward 5yds, its not going...
Forum: Volquartsen 01-16-2020, 01:07 AM
Replies: 169
Views: 80,593
Posted By Flash_80
https://i.imgur.com/sv70wIQ.jpg?1

https://i.imgur.com/sv70wIQ.jpg?1
Forum: 22/45 Mark IV 01-16-2020, 12:59 AM
Replies: 4
Views: 210
Posted By Flash_80
But the biggest thing - BUY FACTORY RUGER...

But the biggest thing - BUY FACTORY RUGER MAGAZINES!!! Don't buy anyone else's magazine for those guns. Others might disagree, but trust me, they suck. The mag bodies and springs and such that...
Forum: 22/45 Mark IV 01-16-2020, 12:57 AM
Replies: 4
Views: 210
Posted By Flash_80
Nothing but the bases. When I knew I was buying...

Nothing but the bases. When I knew I was buying aftermarket bases for the gun, I bought whatever the cheapest 2 pack I could find knowing I was swapping them out anyway. Between a MKIII 22/45, a...
Forum: Scopes, Sights, Rings & Mounts, and Other Optics 01-07-2020, 01:06 AM
Replies: 12
Views: 661
Posted By Flash_80
I'll have to vouch for the Firedot. I only have...

I'll have to vouch for the Firedot. I only have one, albeit on an inline muzzleloader of all things (Natchez blem, camo scope, matched the Optima so it went there), and that thing really is nice. ...
Forum: Volquartsen 01-07-2020, 01:02 AM
Replies: 10
Views: 630
Posted By Flash_80
I think its a great piece and all, but the "worth...

I think its a great piece and all, but the "worth it" part is up in the air. Comes down to what $240 means to one person vs. the other. I'm saying this and I have three of them. Thats the silly...
Forum: Scopes, Sights, Rings & Mounts, and Other Optics 12-30-2019, 04:42 AM
Replies: 12
Views: 427
Posted By Flash_80
I wouldn't have anything over 3MOA unless I was...

I wouldn't have anything over 3MOA unless I was shooting steel challenge or similar. Smaller dot is better to me when your focus isn't large target/fast acquisition.
Forum: Buck Mark / Buck Mark Rifle / Challenger I, II & III / Medalist / International Medalist and No 12-30-2019, 04:33 AM
Replies: 27
Views: 1,400
Posted By Flash_80
Get the Vortex.

Get the Vortex.
Forum: Volquartsen 12-28-2019, 06:18 AM
Replies: 14
Views: 1,333
Posted By Flash_80
He's saying that because the Scorpion is an all...

He's saying that because the Scorpion is an all Volquartsen piece, where the "Black Mamba" (hate that name) is roughly an in house built FrankenRuger where Volquartsen bought a bunch of Ruger 22/45's...
Forum: 22/45 Mark II and III 12-28-2019, 06:10 AM
Replies: 4
Views: 433
Posted By Flash_80
Factory or aftermarket? And what do you mean by...

Factory or aftermarket? And what do you mean by lower parts kit? The trigger assembly guts?
Forum: 10/22 Action 12-28-2019, 06:07 AM
Replies: 27
Views: 2,727
Posted By Flash_80
Yeah, I didn't quite get that either. Never shot...

Yeah, I didn't quite get that either. Never shot it before or after? So if I read that right, then whats the deal? Why in the world would you do custom work to a gun you weren't going to shoot? I...
Forum: 10/22 Action 12-24-2019, 12:13 AM
Replies: 27
Views: 2,727
Posted By Flash_80
Agreed. For the question asked without...

Agreed. For the question asked without elaborating and upping the $$$ factor, this would be the correct answer. The only thing I would do differently would be bumping up to tier 2 for the tension...
Forum: Mk IV 12-19-2019, 07:44 PM
Replies: 29
Views: 1,639
Posted By Flash_80
According to Wirthwein Guns, they are not

According to Wirthwein Guns, they are not
Forum: Scopes, Sights, Rings & Mounts, and Other Optics 12-17-2019, 07:08 PM
Replies: 10
Views: 348
Posted By Flash_80
Thats too spendy for most here to put on any...

Thats too spendy for most here to put on any rifle. A very small crowd that can afford something like that or even justify saving up for it.
Forum: .22 Ammunition (S-L-LR) 12-17-2019, 07:05 PM
Replies: 15
Views: 1,173
Posted By Flash_80
Could be a range specific or event specific rule....

Could be a range specific or event specific rule. They would have it listed in either club rules or the event rules most likely. My club rules state no mini mags, but people use them. Rules there...
Forum: .22 Ammunition (S-L-LR) 12-17-2019, 07:02 PM
Replies: 15
Views: 1,173
Posted By Flash_80
Whatever feeds reliably and doesn't have bad...

Whatever feeds reliably and doesn't have bad primers. Now narrowing that down, and then fitting it within budget is the trick.

Aguila - great primers, waxy and doesn't feed well when its colder....
Forum: Mark III 12-17-2019, 06:52 PM
Replies: 17
Views: 664
Posted By Flash_80
Anyone say the McFadden? Well, if not, then...

Anyone say the McFadden? Well, if not, then that.

If I have a couple of mags, I'm using my thumb. If I'm dragging 5-10 mags out for steel challenge practice or something to where I'm loading...
Forum: 22/45 Mark II and III 12-16-2019, 09:23 PM
Replies: 4
Views: 380
Posted By Flash_80
Believe it or not, Golden Turds would be an...

Believe it or not, Golden Turds would be an option. Granted, there will be bad primers and inconsistent powder charges, but for the most part they've supposedly been one of the hotter of the bulk...
Forum: 10/22 Action 12-14-2019, 02:26 AM
Replies: 25
Views: 2,125
Posted By Flash_80
Basically, a Brimstone job on a BX trigger is...

Basically, a Brimstone job on a BX trigger is going to break at under 2lbs. I've had 2 (one was my cousin's). One breaks at 1.7 bit of takeup. The other at 1.5 with ZERO takeup. Consequently, the...
Forum: 10/22 Action 12-14-2019, 02:23 AM
Replies: 25
Views: 2,125
Posted By Flash_80
Exactly what he said. No options on the BX such...

Exactly what he said. No options on the BX such as "sweet spot" or "low as it can go". It is what it is. And its pretty salty. Brimstone on a BX is better than Brimstone on a standard group by a...
Forum: Scopes, Sights, Rings & Mounts, and Other Optics 12-11-2019, 07:45 PM
Replies: 6
Views: 329
Posted By Flash_80
I've got a VXIII in that model. Crosshairs are...

I've got a VXIII in that model. Crosshairs are thin and could be lost in the limbs I guess on squirrels. The magnification is about perfect for dual purpose though. Can do bench stuff with it just...
Forum: Mk IV 12-08-2019, 10:44 PM
Replies: 6
Views: 553
Posted By Flash_80
Swore that both of mine were steel plungers. I...

Swore that both of mine were steel plungers. I put cornerstones on both, so I've handled the detents and I figure I'd have noticed.
Forum: Mk IV 12-06-2019, 10:05 PM
Replies: 6
Views: 553
Posted By Flash_80
Mine was weak when stock, even weaker I believe...

Mine was weak when stock, even weaker I believe when I replaced it with the Cornerstone ledge. Does your safety have the detent plunger and spring in there?
Forum: Scopes, Sights, Rings & Mounts, and Other Optics 12-01-2019, 07:40 PM
Replies: 10
Views: 780
Posted By Flash_80
My son had one of the Nikon Prostaff rimfire II...

My son had one of the Nikon Prostaff rimfire II scopes for a while, til I sold it and upgraded to a Weaver RV9. It was a pretty good scope. Didn't have the AO to get a clear focus for 25yd group...
Showing results 1 to 25 of 500

 


All times are GMT -5. The time now is 06:42 AM.

Privacy Policy

DMCA Notice

Powered by vBulletin
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Optimisation provided by DragonByte SEO (Lite) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright 2000-2018 RimfireCentral.com
x