RimfireCentral.com Forums - Search Results

Go Back   RimfireCentral.com Forums >

Notices

Join Team RFC to remove these ads.
Showing results 1 to 25 of 45
Search took 0.01 seconds.
Search: Posts Made By: aRBy
Forum: Savage/Stevens 02-12-2017, 11:47 PM
Replies: 51
Views: 10,916
Posted By aRBy
Savage has been very good about sending me...

Savage has been very good about sending me replacement bolt springs.

IF you hang around this forum, you probably shoot a lot of .22LR. If you shoot a lot of .22LR through your Savage Mark II,...
Forum: Savage/Stevens 02-12-2017, 11:44 PM
Replies: 51
Views: 10,916
Posted By aRBy
Yah. I have a Mark II -g as well. I did not lub...

Yah. I have a Mark II -g as well. I did not lub the bolt at all. Shells started getting stuck after about 20,000 rounds or so. I had a new replacement extractor kit that Savage was kind enough to...
Forum: Savage/Stevens 02-12-2017, 11:34 PM
Replies: 16
Views: 1,327
Posted By aRBy
I wrote a whole thread on this. It's good...

I wrote a whole thread on this.

It's good that you have the firearm clean. How many rounds have you put through the rifle?

I just replaced the extractor kit on my Mark II -g after about...
Forum: Take-Down 10/22's 02-12-2017, 11:31 PM
Replies: 37
Views: 4,008
Posted By aRBy
No. I haven't done anything to the rifle. ...

No. I haven't done anything to the rifle.

I think I have at least 2500 rounds through it now. I am keeping the receiver and barrel nice and clean and well lubricated. Other than that, no...
Forum: Take-Down 10/22's 01-24-2017, 12:23 AM
Replies: 37
Views: 4,008
Posted By aRBy
Replaced by manufacturer

Just so you know, Ruger replaced my 10/22 takedown rifle in its entirety. This was a complete replacement; box and all. It included a new bag, magazine, lock, and of course the rifle; everything...
Forum: Savage/Stevens 01-10-2017, 11:13 PM
Replies: 51
Views: 10,916
Posted By aRBy
Keep it clean!

Keeping the chamber clean definitely helps. However, if you can't get more than 200 rounds out of it, you might want a new bolt clip.

I requested a new bolt clip 3 years after replacing the first...
Forum: Take-Down 10/22's 01-09-2017, 07:44 AM
Replies: 37
Views: 4,008
Posted By aRBy
Re: thudd3r

That is precisely correct. thanks.

aRBy
Forum: Take-Down 10/22's 01-09-2017, 07:34 AM
Replies: 37
Views: 4,008
Posted By aRBy
The range/dealer is taking care of it for me. ...

The range/dealer is taking care of it for me. It should be in Ruger's hands hands by now.
Forum: Take-Down 10/22's 01-08-2017, 01:47 PM
Replies: 37
Views: 4,008
Posted By aRBy
The initial crack (on the right side looked like...

The initial crack (on the right side looked like a scratch at first. It was only when I noticed it was cracked through that I realized I had something seriously wrong going on here.
Forum: Take-Down 10/22's 01-08-2017, 01:45 PM
Replies: 37
Views: 4,008
Posted By aRBy
I always wondered what metal alloy Ruger...

I always wondered what metal alloy Ruger receivers were made of.

The basic model is black and does not show dirt and grit like the takedown. I like the takedown for that reason.
Forum: Take-Down 10/22's 01-08-2017, 01:43 PM
Replies: 37
Views: 4,008
Posted By aRBy
Not really! A few thousand rounds of typical...

Not really! A few thousand rounds of typical Remington golden bullet, Thunderbolt, CCI Standard; the usual stuff.
Forum: Take-Down 10/22's 01-08-2017, 01:40 PM
Replies: 37
Views: 4,008
Posted By aRBy
Thank you timberbeast. I doubt I put more than...

Thank you timberbeast. I doubt I put more than 6,000 rounds through it.

It was not dropped, impacted or anything like that. FYI, I returned it to the dealer where I bought it and they are...
Forum: Take-Down 10/22's 01-08-2017, 01:36 PM
Replies: 37
Views: 4,008
Posted By aRBy
That's just normal dirt from .22LR. A little...

That's just normal dirt from .22LR. A little cleaning with Remington Oil Wipes makes it all shiny again.
Forum: Take-Down 10/22's 01-08-2017, 01:34 PM
Replies: 37
Views: 4,008
Posted By aRBy
That is correct. failure to use those clamps...

That is correct. failure to use those clamps causes pins to fall out and the lower trigger mech falls apart.
Forum: Take-Down 10/22's 01-08-2017, 01:32 PM
Replies: 37
Views: 4,008
Posted By aRBy
It was all .22LR; mostly Remington Golden Bullet....

It was all .22LR; mostly Remington Golden Bullet.

The discoloring is just from escaping gas out of the ejector port. When I see it, I know it's time to clean the rifle.
Forum: Take-Down 10/22's 01-05-2017, 11:04 PM
Replies: 37
Views: 4,008
Posted By aRBy
Angry Every manufacturer makes a lemon now and then

I can't believe the fractures in the metal receiver in my Ruger 10/22 Takedown after 18 months of use. Check out the pictures attached.

Regards,

aRBy
Forum: Savage/Stevens 05-24-2016, 12:52 AM
Replies: 17
Views: 1,403
Posted By aRBy
I have found Savage customer service to be...

I have found Savage customer service to be excellent.
Forum: Savage/Stevens 05-24-2016, 12:51 AM
Replies: 11
Views: 3,338
Posted By aRBy
I just bought a Savage 64 and hope to do a...

I just bought a Savage 64 and hope to do a complete review.

The mags are heavy. The spring is very stiff. The 9th and 10th rounds load very hard.

Hollow points don't feed as well as round...
Forum: Savage/Stevens 05-16-2016, 10:26 AM
Replies: 4
Views: 1,739
Posted By aRBy
As a follow-up, I purchased the tech sight...

As a follow-up, I purchased the tech sight package and like it. With the Mark II-g, the Tech Sights give me almost the accuracy (at 25 yds) I enjoy with the Mark II FVT (with the Williams Peep Sight...
Forum: Take-Down 10/22's 05-16-2016, 10:20 AM
Replies: 3
Views: 426
Posted By aRBy
Firing pin won't strike bullet 10% of the time

I'm having a nagging problem with my Ruger 10/22 takedown.

Given any 10-round magazine, at least one bullet will not fire. This is not due to ammo as the bullet comes out without a nick in the...
Forum: .22 Ammunition (S-L-LR) 04-02-2016, 09:36 PM
Replies: 22
Views: 19,760
Posted By aRBy
Thumbs up Thank you for the info.

Fascinating!

Thank you for the pictures and the additional information.

I agree with the "Do not try this at home" advice.
Forum: Savage/Stevens 04-02-2016, 09:12 PM
Replies: 6
Views: 3,377
Posted By aRBy
I'm interested in the Savage 64. How do you like...

I'm interested in the Savage 64. How do you like yours?

Above all, how does it compare to a Ruger 10/22?
Forum: Ruger American Rimfire 04-02-2016, 08:59 PM
Replies: 15
Views: 4,457
Posted By aRBy
Good question, Mr. Torque! I'm not a fan of...

Good question, Mr. Torque! I'm not a fan of scopes and re-dots but we (The Mrs. and I) have progressive trifocals. Conventional buckhorn/tang sights are always a challenge. The fire sight on the...
Forum: Savage/Stevens 04-02-2016, 08:33 PM
Replies: 4
Views: 1,739
Posted By aRBy
Tech Sights for Savage Mark II

Has anyone tried the Tech-SIGHTS adjustable aperture sights for the Savage Mark II? If so, did you like it?

Here's the Instruction Sheet for the Mark II package:
...
Forum: Savage/Stevens 04-02-2016, 08:25 PM
Replies: 51
Views: 10,916
Posted By aRBy
Hi Doc! As long as I do NOT take the bolt...

Hi Doc!

As long as I do NOT take the bolt apart, I have found a light coating of oil seems to be fine. Where I was screwing up was taking the bolt apart and using oil and/or solvents to clean...
Showing results 1 to 25 of 45

 


All times are GMT -5. The time now is 03:34 AM.

Privacy Policy

DMCA Notice

Powered by vBulletin
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Search Engine Optimisation provided by DragonByte SEO (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Copyright 2000-2018 RimfireCentral.com
x