RimfireCentral.com Forums - Search Results

Go Back   RimfireCentral.com Forums >

Join Team RFC to remove these ads.
Showing results 1 to 25 of 500
Search took 0.05 seconds.
Search: Posts Made By: ivan
Forum: 10/22 Stocks - Factory & Aftermarket 01-05-2022, 10:44 PM
Replies: 14
Views: 840
Posted By ivan
I picked up a sporter stock (I hate the curved...

I picked up a sporter stock (I hate the curved carbine butt) in the trading post and sanded the barrel channel out.
Forum: Handgun 01-02-2022, 10:38 PM
Replies: 18
Views: 715
Posted By ivan
inexpensive != cheap

inexpensive != cheap
Forum: RFC Community Forum 12-30-2021, 09:26 PM
Replies: 23
Views: 635
Posted By ivan
I keep a mini spinning rod - single piece, 3' or...

I keep a mini spinning rod - single piece, 3' or so rod, with 4lb test line in each of my cars. Run small beetle spins and micro size plastics
Forum: RFC Community Forum 11-18-2021, 06:08 PM
Replies: 10
Views: 530
Posted By ivan
“No one is finally dead until the ripples they...

“No one is finally dead until the ripples they cause in the world die away, until the clock wound up winds down, until the wine she made has finished its ferment, until the crop they planted is...
Forum: Open Rimfire 11-18-2021, 06:02 PM
Replies: 60
Views: 2,618
Posted By ivan
Range behavior is different from competition...

Range behavior is different from competition behavior is different from "out in the field" is different from concealed carry (ok, the last two may be very similar...)

Almost never use safeties...
Forum: Scopes, Sights, Rings & Mounts, and Other Optics 11-14-2021, 09:27 PM
Replies: 16
Views: 937
Posted By ivan
You just need to get a replacement apature and a...

You just need to get a replacement apature and a new roll pin and you should be good to go. Quick search shows DPMS made a "National Match" wtih a 0.052" hole, and Bushmaster offered a 0.040"
Forum: Scopes, Sights, Rings & Mounts, and Other Optics 10-27-2021, 11:27 PM
Replies: 19
Views: 1,215
Posted By ivan
Well, my 10/22 build has worn a 6.5-20 and...

Well, my 10/22 build has worn a 6.5-20 and currently wears a 8-32 .... but 80%+ of my rifle shooting is from a bench
Forum: Scopes, Sights, Rings & Mounts, and Other Optics 10-27-2021, 11:25 PM
Replies: 11
Views: 870
Posted By ivan
The obvious solution is of course to get a second...

The obvious solution is of course to get a second rifle for say, 50+ yard work and put a scope on it appropriate for such :)

On a more serious note, it is possible to adjust the parallax on a...
Forum: Open Rimfire 10-27-2021, 11:12 PM
Replies: 13
Views: 664
Posted By ivan
There are a couple of companies that make them,...

There are a couple of companies that make them, including much longer barrel offerings (12-18") and a nice range of rounds.

If I had the money (or skills equipment and time) I'd love to do a fixed...
Forum: Open Rimfire 10-27-2021, 11:08 PM
Replies: 7
Views: 481
Posted By ivan
Sold the one I had a few months ago ...

Sold the one I had a few months ago ...
Forum: Factory Stock 10/22's 10-27-2021, 11:06 PM
Replies: 13
Views: 1,173
Posted By ivan
I just really dislike the curve of the carbine...

I just really dislike the curve of the carbine butt stock. Can live with the barrel band, but strongly prefer sporter style up front as well.
Forum: 10/22 Barrels - Factory & Aftermarket 10-12-2021, 06:32 PM
Replies: 11
Views: 1,049
Posted By ivan
Thing about twist rate is that it is related to...

Thing about twist rate is that it is related to bullet length, not weight. Though weight can be related to length when you have a cylinder of fixed diameter.

In theory, if the copper bullet is...
Forum: Computer Help and Troubleshooting 09-27-2021, 07:46 PM
Replies: 10
Views: 919
Posted By ivan
80' through two sets of exterior walls? Run a...

80' through two sets of exterior walls? Run a cable. Once you have a cable run, either plug into a switch and then hang an access point off that or just plug in an access point directly (I'd go w/...
Forum: RFC Community Forum 09-25-2021, 09:55 PM
Replies: 22
Views: 805
Posted By ivan
Nope. But then, I'm not in a flood zone or on...

Nope. But then, I'm not in a flood zone or on the coast.
Forum: RFC Community Forum 09-18-2021, 11:19 AM
Replies: 8
Views: 330
Posted By ivan
Found some good 2 3/4" data at...

Found some good 2 3/4" data at https://castboolits.gunloads.com/showthread.php?414204-12ga-and-20ga-Active-Hull-Reloading-Data

With leads to maybe 3" data....

Anyway, it appears there is a...
Forum: Anything 10/22 09-04-2021, 12:54 PM
Replies: 78
Views: 7,078
Posted By ivan
Not gonna read thru the replies but I'm sure the...

Not gonna read thru the replies but I'm sure the "free" stuff has been mentioned -

Auto bolt release mod
Bedding - aluminum tape or JBWeld
Drilling cleaning hole at rear of receiver

Other...
Forum: RFC "Get Togethers" 08-31-2021, 05:54 PM
Replies: 27
Views: 1,556
Posted By ivan
Howdy from the edge of Alachua County (I'm a few...

Howdy from the edge of Alachua County (I'm a few miles from newberry, high springs, and alachua)
Forum: 10/22 Action 08-29-2021, 06:53 PM
Replies: 48
Views: 3,775
Posted By ivan
For the cost of a BX I'd rather send my metal...

For the cost of a BX I'd rather send my metal trigger group to Brimstone
Forum: Black Powder 08-29-2021, 06:52 PM
Replies: 0
Views: 660
Posted By ivan
need powder?

Powder Valley Inc has a good variety of real black powder in stock
Forum: RFC Community Forum 08-27-2021, 05:40 PM
Replies: 34
Views: 1,054
Posted By ivan
The wife and I drive a few miles down the road to...

The wife and I drive a few miles down the road to one of the many local fields being picked, she gets out and speaks to the workers, passes them $10 and a cold six pack of beer, they spend 10 minutes...
Forum: Black Powder 08-27-2021, 05:36 PM
Replies: 2
Views: 373
Posted By ivan
Wonderful offer, thanks! ..... Came with some...

Wonderful offer, thanks! ..... Came with some Pyrodex, and I can find some more locally but I'd really rather shoot real black. I've found some online, but buying 3-5lbs to make the hazmat shipping...
Forum: Open Rimfire 08-27-2021, 05:31 PM
Replies: 7
Views: 578
Posted By ivan
For your trajectory, it depends on velocity and...

For your trajectory, it depends on velocity and how high the sights/scope are/is above the centerline of the bore but I would be that it could be higher at 50 yards (depending....)

For the ammo...
Forum: Black Powder 08-18-2021, 10:19 PM
Replies: 10
Views: 1,536
Posted By ivan
As a new owner of a Lyman-marked Uberti-made 1858...

As a new owner of a Lyman-marked Uberti-made 1858 this of great interest to me.



Hrm... my cylinder (and your BP cylinder) has notches between each nipple to lower the hammer into so it can run...
Forum: Black Powder 08-18-2021, 10:14 PM
Replies: 2
Views: 373
Posted By ivan
whoopsie! joined the club

I really didn't mean to but I couldn't stop myself... on a different forum, someone local to me posted a Lyman (Uberti made) 1858 New Army for a stupid low price. As a bonus it came with about 300...
Forum: Black Powder 08-18-2021, 10:07 PM
Replies: 5
Views: 446
Posted By ivan
777 would give more oomph... but now you know...

777 would give more oomph... but now you know everything I know about it, so I'd do a lot more research
Showing results 1 to 25 of 500

 


All times are GMT -5. The time now is 06:27 PM.

Privacy Policy

DMCA Notice

Powered by vBulletin
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Search Engine Optimisation provided by DragonByte SEO (Lite) - vBulletin Mods & Addons Copyright © 2022 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2022 DragonByte Technologies Ltd.
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2022 DragonByte Technologies Ltd.
Copyright 2000-2018 RimfireCentral.com
x