RimfireCentral.com Forums - Search Results

Go Back   RimfireCentral.com Forums >

Notices

Join Team RFC to remove these ads.
Showing results 1 to 25 of 500
Search took 0.04 seconds.
Search: Posts Made By: cleanprone
Forum: Winchester 52 05-18-2020, 11:19 AM
Replies: 6
Views: 469
Posted By cleanprone
Handstop fit in rail

Try turning ninety degrees- some of the rail accessories work in both the Anschutz and the American rails by rotating 90 degrees.
Forum: CZ / Brno 05-14-2020, 04:09 PM
Replies: 10
Views: 598
Posted By cleanprone
457 barrel for 455

Have just received, installed and shot a replacement 24" 457 barrel in my 455 American. I contacted the CZ parts department and it was shipped immediately and received promptly. The barrel was...
Forum: Winchester 52 05-12-2020, 09:46 AM
Replies: 3
Views: 287
Posted By cleanprone
palm rest

Lots of pics of the cork ball palm rest in the Brophy Springfield book. Check your browser for "swiss ball palm rest" or "Freeland ball palm rest." Been around awhile, see this on many...
Forum: Model 37/40X 04-30-2020, 03:13 PM
Replies: 4
Views: 324
Posted By cleanprone
Extend length of pull

Looks like somebody needed some more length of pull, got some all thread which screwed into the welded on nut and locked with another nut, another plate for the butt pad and/or hook, Didn't the...
Forum: Anschutz 04-29-2020, 09:50 AM
Replies: 13
Views: 714
Posted By cleanprone
Cast off

Similar cast off on my 1963 1411 stock. Same with my 1965 1413 thumbhole. Especially noticeable with the hook plate on and laid on the side. My 1813 doesn't seem to have as much cast off, but then...
Forum: Anschutz 03-25-2020, 08:28 AM
Replies: 7
Views: 927
Posted By cleanprone
"Extended" Rail

Very common here in the 'states" to get the scope mounted far enough forward to get correct eye relief, doesn't hurt head position either. Carl Joos (ChampionShooters Supply is said to have...
Forum: Anschutz 02-09-2020, 08:46 AM
Replies: 5
Views: 554
Posted By cleanprone
1907 BR

I have my 1907 in a Stith BR stock, big Sightron and Harrell tuner. Does well with Center-X and will hold its own with some of the full customs
Forum: 10/22 Barrels - Factory & Aftermarket 01-29-2020, 06:20 PM
Replies: 4
Views: 815
Posted By cleanprone
Shilen for Rimfire BR

Look at the equipment lists for USBR and ARA and other Rimfire BR competitions. Our local shooters use more Shilen barrels than just about anything, including Muehler, Hart Lilja, RockCreek. The...
Forum: 10/22 Stocks - Factory & Aftermarket 01-27-2020, 03:23 PM
Replies: 11
Views: 1,256
Posted By cleanprone
Narrow but good

Stock would be the Anschutz Thumbhole. Nice heft and flat forend, could add a 3" block if allowed. Although this stock doesn't have a thumb rest it is comfortable for small hands. I have one, sky...
Forum: Winchester 52 12-26-2019, 02:46 PM
Replies: 5
Views: 515
Posted By cleanprone
Most probably sear

This is the classic indication of too little sear engagement. Someone may have "adjusted" the contact angles by filing, but more likely just backed the sear engagement screw out to the point it will...
Forum: Winchester 52 11-24-2019, 07:20 PM
Replies: 25
Views: 6,328
Posted By cleanprone
Speedlock with Hartman case

David Condon has pictures of an early 52 with Hartman NRA case on his site for sale..
Forum: Henry 10-22-2019, 04:57 PM
Replies: 4
Views: 1,261
Posted By cleanprone
6X Malcomb

I have the 6X mounted on a Frontier. The drop of the GB stock may make the scope uncomfortable to use, not so on the Frontier. Very handy at 50 feet offhand and groups well at 50 yards off bench...
Forum: Winchester 52 09-23-2019, 05:52 PM
Replies: 10
Views: 1,140
Posted By cleanprone
Early 52s

Shooter grade Pre-A with average bluing wear and stock marks, with original sights, barrel band will sell in NE Ohio for $500 or more, better condition equal more $s. I got a nice slowlock with good...
Forum: Martini 06-27-2019, 02:00 PM
Replies: 38
Views: 4,804
Posted By cleanprone
go ahead

I redid my Mark II awhile back. The original was purchased from Navy Arms at an OGCA show and was complete with good blueing, sights, handstop, etc. Lots of small blemishes and pressure marks and...
Forum: Anschutz 06-04-2019, 06:11 PM
Replies: 13
Views: 2,313
Posted By cleanprone
Anschutz used in top level BR competition

To answer South Pender question- although the Anschutz BR rifles are almost turn key ready (add tuner, etc.) they don't show up much on the equipment lists of the big tournaments. Where the one...
Forum: Model 37/40X 05-19-2019, 04:02 PM
Replies: 174
Views: 62,699
Posted By cleanprone
More info?

What's the serial number on that one? Looks like the early stock.
Forum: Anschutz 04-17-2019, 07:36 PM
Replies: 10
Views: 745
Posted By cleanprone
Top coat for stippled areas

When refinishing the entire stock I'll use same finish but thinned. Last few rifles I've done I've used pure tung oil applied with soft rag or toothbrush, or MinWax water based poly thinned with...
Forum: Anschutz 04-17-2019, 01:36 PM
Replies: 10
Views: 745
Posted By cleanprone
Stippling

I've done this now on several Anschutz rifles and an RWS 75. Use same finish as you do on the rifle, but thin down and use several very light coats until just covered. Remember you can't cut down...
Forum: Anschutz 03-19-2019, 01:57 PM
Replies: 59
Views: 19,857
Posted By cleanprone
Anschutz 1761, what sport/class in Europe

This post to Tim S. or another overseas reader. What discipline or sport shooting are these MPR type rifles being used? One can't help but notice the similarities in the new CZ, Tikka and Anschutz...
Forum: Savage/Stevens 03-10-2019, 03:13 PM
Replies: 4
Views: 875
Posted By cleanprone
20" Mark II, "honed"

Now there is a 20" bull on the GM website and advertised as being "honed." This is not in the usual description of Green Mountain barrels. We'll see.
Forum: 10/22 Barrels - Factory & Aftermarket 03-10-2019, 03:02 PM
Replies: 5
Views: 819
Posted By cleanprone
LVT barrel

You will not get an equivalent barrel anywhere for under $100, but probably a quick sell at $75... The barrel quality if very good and the profile is desirable.
Forum: CZ / Brno 03-07-2019, 04:16 PM
Replies: 2
Views: 439
Posted By cleanprone
Just pulled up some specs

on a CZ related site which listed the 457 MTR weight as 8 lb. 9 oz. Evidently typo or mistake on CZ USA website. This will put the rifle over 8.5 for NRA light rifle and maybe some BR classes with...
Forum: Savage/Stevens 02-28-2019, 01:31 PM
Replies: 4
Views: 875
Posted By cleanprone
Green Mountain barrel

Green Mountain is now advertising a replacement barrel for the Savage Mark II 16", nitride, fluted, threaded with 15" twist. I'd go for a 20" bull, fluted or a 19-20" heavy taper. Evidently this...
Forum: Anschutz 02-25-2019, 10:33 AM
Replies: 9
Views: 1,067
Posted By cleanprone
SBS- yup, lookin' like a Lischert, non-calibrated...

SBS- yup, lookin' like a Lischert, non-calibrated head, especially with the aluminum lens caps. I saw an early Spot Shot at a local club show recently with the guide groove instead of the Pope rib.
Forum: Anschutz 02-24-2019, 11:33 PM
Replies: 9
Views: 1,067
Posted By cleanprone
Freeland or Womack front, is the rear tube sight...

Freeland or Womack front, is the rear tube sight connected to the Anschutz rear sight? If so I'm at a loss. The long front sight often had a two-step base for 50 and 100 yards, known as a "Dual...
Showing results 1 to 25 of 500

 


All times are GMT -5. The time now is 04:41 PM.

Privacy Policy

DMCA Notice

Powered by vBulletin
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Search Engine Optimisation provided by DragonByte SEO (Lite) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright 2000-2018 RimfireCentral.com
x