Forum: RFC Community Forum
04-12-2018, 03:21 AM
|
|
Replies: 151
Views: 10,754
|
|
Forum: Shooting Accessories
12-10-2015, 06:22 PM
|
|
Replies: 77
Views: 7,835
|
|
Forum: CZ / Brno
04-25-2004, 03:09 PM
|
|
Replies: 12
Views: 671
|
|
Forum: Shooting Accessories
03-09-2004, 09:02 PM
|
|
Replies: 221
Views: 38,143
|
|
Forum: CZ / Brno
03-07-2004, 10:55 AM
|
|
Replies: 19
Views: 1,471
22 Big
Your are/were correct in your assesment of my scope, rings, and the Varmint combination.
The CZ mount make the scope look like it was manufactured on the gun with 1.5 mm clearance between the...
|
|
Forum: Shooting Accessories
03-05-2004, 12:27 AM
|
|
Replies: 221
Views: 38,143
Cheap skate.........pennies
Super glue, rubber cement etc. or just onto lengths of tape.
Make ""INTERESTING"" change and conversation starters when you spend them after recovery. Suspending or sticking them above a...
|
|
Forum: CZ / Brno
02-29-2004, 10:50 AM
|
|
Replies: 2
Views: 452
That CZ 452 Weaver rail adapter reads like...
That CZ 452 Weaver rail adapter reads like "Brookie's" rig. I'm sure you have encountered his good suggestions and commercial offerings on this forum.
Way good price (better than I found) price...
|
|
Forum: CZ / Brno
02-29-2004, 10:36 AM
|
|
Replies: 19
Views: 1,471
22big
Per your post above, jumped right on the CZ rings. IF they aren't tall enough to mount Cabela's big ol' 3.5-10x44AO Alaskan Guide with its 2.290" (56mm.) objective bell with enough bbl. clearance...
|
|
Forum: CZ / Brno
02-28-2004, 01:27 PM
|
|
Replies: 11
Views: 832
Pbridges
Plastic mags are not a problem that I am aware of....as an O.G. I have never trusted plastics to the extent I do steel.....they're probably over engineered to a degree I will never understand.
...
|
|
Forum: CZ / Brno
02-27-2004, 09:46 PM
|
|
Replies: 14
Views: 715
vmaxx
The deed (order phoned to CTD) was done this morning. If the CZ rings at .625 in. are too squatty, I will study the situation and consider your customization option. Otherwise, rings go back to CTD...
|
|
Forum: CZ / Brno
02-27-2004, 09:02 PM
|
|
Replies: 11
Views: 832
Been there...dunnitoo
I took posession of my Varmint yesterday and made the same discovery....unfortunately I didn't have an "rbeckey" to advise me properly and managed to take a small chip from the wood below the bolt...
|
|
Forum: CZ / Brno
02-26-2004, 10:35 PM
|
|
Replies: 14
Views: 715
Here goes a first Post.......
Have the same...
Here goes a first Post.......
Have the same decisions to make here. Am planning to order the CZ factory rings (Cheaper Than Dirt) to mount a Cabela's Alaskan Guide 3.5-10 X 44mmAO . Trick will...
|
