RimfireCentral.com Forums - Search Results

Go Back   RimfireCentral.com Forums >

Notices

Join Team RFC to remove these ads.
Showing results 1 to 25 of 500
Search took 0.04 seconds.
Search: Posts Made By: newbie2
Forum: CZ / Brno 07-12-2021, 08:48 PM
Replies: 8
Views: 509
Posted By newbie2
No problem. I have tough toes at my age. ...

No problem. I have tough toes at my age.

Jut a note: You can use a 223 Rem case to measure the base on the .22 LR. Measure the case with dial caliper, zero out, insert 22 LR projectile first and...
Forum: CZ / Brno 07-11-2021, 02:17 PM
Replies: 8
Views: 509
Posted By newbie2
Did you measure the base of the 30 grain load? It...

Did you measure the base of the 30 grain load? It doesn't take much to tighten things up.
Forum: CZ / Brno 07-07-2021, 09:59 PM
Replies: 17
Views: 826
Posted By newbie2
I have this bad habit of buying all things .223. ...

I have this bad habit of buying all things .223. I like all my rifles to shoot well.

Am\nd yes, the Hornet is a CZ and it shoots very well.
Forum: CZ / Brno 07-07-2021, 07:11 PM
Replies: 17
Views: 826
Posted By newbie2
I have tried all the Hornady's I could find, CCI,...

I have tried all the Hornady's I could find, CCI, Federal, few Remingtons and Winchester Dynapoint.
The Federal 40 grain was the most accurate, but at that weight I will go to my Hornet. ( I have...
Forum: CZ / Brno 07-07-2021, 03:51 PM
Replies: 17
Views: 826
Posted By newbie2
455 American w/ 22 WMR barrel is a pig.

I am looking for an aftermarket barrel for my 455 in 22 WMR. I have tried all of my tricks and it still won't shoot under 4 inches at 50 yards. Checked Crown, fiddled with torque, shimmed and then...
Forum: CZ / Brno 12-27-2020, 09:22 PM
Replies: 19
Views: 2,579
Posted By newbie2
First, what I use with good luck , then the...

First, what I use with good luck , then the lesson learned I have used Slip 2000 Carbon Remover with good results. I wet a swab and let it soak for half hour and use a nylon brush. Tough ones get a...
Forum: RFC Community Forum 10-11-2020, 09:48 PM
Replies: 32
Views: 1,436
Posted By newbie2
In an older house with the steel mesh in the...

In an older house with the steel mesh in the plaster, you might have a Faraday Cage blocking signals.
Forum: .22 Ammunition (S-L-LR) 10-11-2020, 09:38 PM
Replies: 11
Views: 1,406
Posted By newbie2
I left 5 boxes sitting on the bench at the range...

I left 5 boxes sitting on the bench at the range and it was there for a week.
Forum: Savage/Stevens 10-11-2020, 09:03 PM
Replies: 29
Views: 3,403
Posted By newbie2
One thing often overlooked is point of am vs....

One thing often overlooked is point of am vs. point of impact. For groups offset your POA an inch or inch and half. Do not shoot out your point of aim.
Forum: Stocks: Making, Repairing, Refinishing, Modifying, and Bedding 08-28-2020, 07:49 PM
Replies: 30
Views: 2,510
Posted By newbie2
Check the MSDS sheets.

Check the MSDS sheets.
Forum: RFC Community Forum 08-18-2020, 09:02 PM
Replies: 24
Views: 890
Posted By newbie2
dlong, I know the underlying coverage...

dlong,
I know the underlying coverage requirements vary by state law. I worked most states in the NE US. Most had a $50,000 or $100,000 required minimum.
Their premium with the amounts you quote...
Forum: Scopes, Sights, Rings & Mounts, and Other Optics 08-18-2020, 08:51 PM
Replies: 4
Views: 504
Posted By newbie2
Look at Vortex. I keep an eye out for...

Look at Vortex. I keep an eye out for discontinued models, kinda, like 2020 cars in the fall of when the 2021's come out Camera Land.
Forum: CZ / Brno 08-18-2020, 08:31 PM
Replies: 46
Views: 4,117
Posted By newbie2
Question?

Would this apply to pop corn fa*ts? My wife thinks so. :D
Forum: CZ / Brno 08-18-2020, 08:24 PM
Replies: 9
Views: 585
Posted By newbie2
My unsupported theory of carbon rings is a rough...

My unsupported theory of carbon rings is a rough patch in the taper of the chamber to rifling.
Lapped, premium barrels are less likely to have a ring. And stay cleaner linger. My opinion is woerh...
Forum: RFC Community Forum 08-17-2020, 09:32 PM
Replies: 24
Views: 890
Posted By newbie2
If you have a home or retirement account and not...

If you have a home or retirement account and not enough liability insurance you can lose it all.
Go with the minimum to satisfy the threshold to buy an umbrella. Usually that is a Single limit 100K...
Forum: CZ / Brno 08-17-2020, 07:13 PM
Replies: 9
Views: 585
Posted By newbie2
My keyboard diagnosis is with Al. The first shot...

My keyboard diagnosis is with Al. The first shot softens the carbon ring a tad as does the second.
The 22 WMR would need a lot of fast shooting to heat a barrel enough for that to cause wander.
Forum: CZ / Brno 08-16-2020, 08:49 PM
Replies: 17
Views: 1,696
Posted By newbie2
I lost the sensitivity in my trigger finger by...

I lost the sensitivity in my trigger finger by running a clam knife into my hand.
Didn't go through but it crowned on the other side. Messed up my guitar playing too.
Not fun.
She was tall...
Forum: CZ / Brno 08-16-2020, 08:44 PM
Replies: 10
Views: 1,190
Posted By newbie2
I love the spicy aroma of the hickory nut hulls. ...

I love the spicy aroma of the hickory nut hulls. I used ti fill a couple of mesh onion bags full and keep in the garage and basement for the winter. I had a pretty good stand of the shag bark...
Forum: Rifle 08-13-2020, 09:15 PM
Replies: 24
Views: 1,939
Posted By newbie2
A decent A3-03 action is probably worth $150 to...

A decent A3-03 action is probably worth $150 to 200 to the right party.
Forum: Model 41 Pistol 08-13-2020, 09:09 PM
Replies: 14
Views: 1,336
Posted By newbie2
If you have to modify something to fit a gun, the...

If you have to modify something to fit a gun, the first rule is to modify the cheapest part. Just in case Murphy comes to visit.
Forum: CZ / Brno 08-13-2020, 09:03 PM
Replies: 1
Views: 357
Posted By newbie2
After market barrel for 457.

Are there any after market barrels for the AT-ONE on 17 HMR?
Forum: CZ / Brno 08-13-2020, 08:49 PM
Replies: 9
Views: 875
Posted By newbie2
Pretty sure it is a for a 455 . ...

Pretty sure it is a for a 455 .

https://www.petespillars.com/store/p6/CZ_455_Profiled_Pillar_Kit_DIY_Stock_Pillar_Bedding_with_Upgraded_Action_Screws.html
Forum: CZ / Brno 08-13-2020, 08:40 PM
Replies: 33
Views: 4,588
Posted By newbie2
SwatchDog, We are going to find out together.

SwatchDog, We are going to find out together.
Forum: CZ / Brno 08-12-2020, 08:56 PM
Replies: 33
Views: 4,588
Posted By newbie2
I have a Sinclair bench rest adapter in the fore...

I have a Sinclair bench rest adapter in the fore stock of my 452. It keeps it from rocking. Add the equivalent to the back and it should get me abused to no end at range.
But, if I win, who cares....
Forum: CZ / Brno 08-12-2020, 08:52 PM
Replies: 9
Views: 875
Posted By newbie2
I think the notch in the pillar is for the 455. ...

I think the notch in the pillar is for the 455. My 452 is solid . I think.

Dern, No I have go dig into the safe.
Showing results 1 to 25 of 500

 


All times are GMT -5. The time now is 07:43 PM.

Privacy Policy

DMCA Notice

Powered by vBulletin
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Search Engine Optimisation provided by DragonByte SEO (Lite) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
Copyright 2000-2018 RimfireCentral.com
x