RimfireCentral.com Forums - Search Results

Go Back   RimfireCentral.com Forums >

Notices

Join Team RFC to remove these ads.
Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: elh0102
Forum: Anschutz 12-06-2019, 08:12 PM
Replies: 21
Views: 1,298
Posted By elh0102
I don't think there is a light-pull fix for it,...

I don't think there is a light-pull fix for it, not using Anschutz parts. But I'm sure Neal can tell you.
Forum: Anschutz 12-06-2019, 04:25 PM
Replies: 21
Views: 1,298
Posted By elh0102
I think that is about what you can expect from...

I think that is about what you can expect from just changing springs. After Neal replaced the cam in mine, I think it's at about 4 ounces. But be advised, you can't get it much over about 6 ounces...
Forum: Anschutz 12-05-2019, 10:32 PM
Replies: 21
Views: 1,298
Posted By elh0102
You can send a 5109 two-stage trigger to Neal...

You can send a 5109 two-stage trigger to Neal Stepp and have it converted to a light pull trigger. It's a simple matter of replacing the cam with one from a previous Anschutz trigger. However, it...
Forum: Anschutz 11-30-2019, 05:07 PM
Replies: 11
Views: 458
Posted By elh0102
If your action is typical of most 1416 rifles...

If your action is typical of most 1416 rifles (I've had 2), it needs neither bedding nor pillars. Anschutz inletting is usually a bit loose (good, no binding), and with only modest torque on the...
Forum: Anschutz 11-28-2019, 07:39 AM
Replies: 34
Views: 2,988
Posted By elh0102
I've owned a half dozen Anschutz rifles, and had...

I've owned a half dozen Anschutz rifles, and had experience with a few more, and I've never seen one that needed any bedding work. I had one (1416 HB Classic) that was not shooting to my...
Forum: Anschutz 11-26-2019, 07:21 AM
Replies: 11
Views: 709
Posted By elh0102
Groups are measured C-T-C, measure the outside...

Groups are measured C-T-C, measure the outside diameter at largest point, subtract bullet diameter. The group pictured is roughly a half inch. Quarter inch groups at 50 yards are easy to shoot with a...
Forum: Ultimate 10/22 11-19-2019, 09:36 PM
Replies: 23
Views: 1,385
Posted By elh0102
Agree on the bedding. I used to do rimfire BR...

Agree on the bedding. I used to do rimfire BR with some very high end custom bolt guns. I have since done more with lighter weight sporter bolt guns as well as a couple of Kidd autoloaders. IMO,...
Forum: Ultimate 10/22 11-18-2019, 07:31 PM
Replies: 23
Views: 1,385
Posted By elh0102
The bedding should have no impact on your barrel...

The bedding should have no impact on your barrel decision. The action is bedded, but the barrel is free floating, so it makes no difference which barrels you might be switching around. That's not to...
Forum: Anschutz 11-17-2019, 08:19 PM
Replies: 20
Views: 1,139
Posted By elh0102
Years ago I shot rimfire BR with a couple of...

Years ago I shot rimfire BR with a couple of Calfee built rifles on 40X actions. They were very accurate, as you would expect. I have a 54.18 MSR that is also very accurate, and on any given day...
Forum: Anschutz 11-16-2019, 10:53 AM
Replies: 20
Views: 1,139
Posted By elh0102
Most BR matches are won with single shot actions,...

Most BR matches are won with single shot actions, but not because they are single shot. No one is going to risk bullet damage by using a magazine, so there is no reason to offer a repeating action. I...
Forum: Anschutz 11-16-2019, 07:31 AM
Replies: 20
Views: 1,139
Posted By elh0102
No.

No.
Forum: .22 Ammunition (S-L-LR) 11-15-2019, 06:51 AM
Replies: 30
Views: 2,659
Posted By elh0102
I used some of this ammo 30+ years ago for...

I used some of this ammo 30+ years ago for squirrel hunting, and it was reasonably accurate and performed well on the critter. Have no idea about the current product, shoot only sub-sonic ammo now.
Forum: Anschutz 11-06-2019, 03:54 PM
Replies: 93
Views: 6,275
Posted By elh0102
Kevin, I don't know your plans for the rifle, but...

Kevin, I don't know your plans for the rifle, but I would hesitate to put a ton of money in a custom sporter weight rifle. That's assuming your goal is accuracy, and not the aesthetics of a beautiful...
Forum: Anschutz 11-06-2019, 10:03 AM
Replies: 93
Views: 6,275
Posted By elh0102
I did a lot of rimfire BR years ago, mostly with...

I did a lot of rimfire BR years ago, mostly with a couple of Bill Calfee rifles built on 40X actions. Based on that experience, and a lot of casual shooting since, I believe your expectations are...
Forum: Anschutz 11-01-2019, 07:36 AM
Replies: 5
Views: 436
Posted By elh0102
Glad it worked out well. Cutting a rifle barrel...

Glad it worked out well. Cutting a rifle barrel is always risky, and the results cannot be certain.
Forum: Anschutz 10-26-2019, 07:05 AM
Replies: 8
Views: 781
Posted By elh0102
From what I have seen, Anschutz has only improved...

From what I have seen, Anschutz has only improved its products over the years. Current manufacturing equipment allows consistent tolerances that were not possible in the old days. You don't remain a...
Forum: Anschutz 10-16-2019, 07:34 AM
Replies: 12
Views: 691
Posted By elh0102
I like the Weaver style Signature rings better,...

I like the Weaver style Signature rings better, used with a pair of J&P adapters. The material will not scratch the receiver, and I've never had them loosen when used as directed. I've never used the...
Forum: Anschutz 10-14-2019, 09:55 PM
Replies: 26
Views: 2,353
Posted By elh0102
I admire your endurance, over 600 rounds would be...

I admire your endurance, over 600 rounds would be tiring for me, and a very long day. Don't give up on the Center-X, it's typically one of the best choices in Anschutz rifles. Different lots can...
Forum: Anschutz 10-14-2019, 10:30 AM
Replies: 6
Views: 591
Posted By elh0102
The Weaver is a decent scope, but if you can find...

The Weaver is a decent scope, but if you can find one of the BR model Leupold scopes, it is better. I was active in BR in the 80's and 90's. Among serious competitors Leupold outnumbered everyone by...
Forum: Anschutz 10-14-2019, 07:40 AM
Replies: 6
Views: 591
Posted By elh0102
The old Leupold BR 24X and 36X scopes were very...

The old Leupold BR 24X and 36X scopes were very popular in that era. I expect you can find used ones on some of the bench rest related forums. But, time hasn't stood still in scope design during the...
Forum: Ultimate 10/22 10-11-2019, 07:36 AM
Replies: 27
Views: 972
Posted By elh0102
If I understand, the only thing new is the...

If I understand, the only thing new is the barrel, and all the issues you describe could be the result of an imperfect barrel fitment. That could result from machining error in the barrel shank. You...
Forum: Anschutz 09-28-2019, 10:02 AM
Replies: 3
Views: 239
Posted By elh0102
I should mention one other thing about setting up...

I should mention one other thing about setting up the trigger with this light-pull part. One would think by installing a heavier spring, you could achieve any pull weight you want, but not so. If...
Forum: Anschutz 09-28-2019, 07:31 AM
Replies: 3
Views: 239
Posted By elh0102
My experience has been that the lightest J&P...

My experience has been that the lightest J&P spring will reduce it to somewhere in the 9-11 ounce range. The geometry of the design doesn't allow much lower, unless you replace the cam lever with one...
Forum: Anschutz 09-27-2019, 07:27 AM
Replies: 4
Views: 290
Posted By elh0102
To the OP, looks like you might have been reading...

To the OP, looks like you might have been reading the directions for the two-stage trigger, in which the sear adjustment is opposite the single stage.
Forum: Anschutz 09-26-2019, 07:18 AM
Replies: 3
Views: 493
Posted By elh0102
I notice you replied "like the Manners", which...

I notice you replied "like the Manners", which suggests it may not be a Manners stock. That issue aside, I sold two like-new 1416 HB Classic rifles for $800 each, which I believe is a fair price for...
Showing results 1 to 25 of 500

 


All times are GMT -5. The time now is 05:42 AM.

Privacy Policy

DMCA Notice

Powered by vBulletin
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Search Engine Optimisation provided by DragonByte SEO (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Copyright 2000-2018 RimfireCentral.com
x